Study of Adhesive Strength in Polymer Plate Heat and Mass Exchanger

Mohd Amirul Mukminin bin Alias, Mohd amirul (2011) Study of Adhesive Strength in Polymer Plate Heat and Mass Exchanger. [Final Year Project] (Unpublished)

[thumbnail of Study_of_Adhesive_Strength_in_Polymer_Plate_Heat_and_Mass_Exchanger.pdf]
Preview
PDF
Study_of_Adhesive_Strength_in_Polymer_Plate_Heat_and_Mass_Exchanger.pdf

Download (4MB)

Abstract

Open Cycle Liquid Desiccant Air Conditioner system is promising solution for air conditioning in hot and humid climates like a tropical region South East Asia. The system used cross flow type plate heat exchanger made by thin sheets of polymer for both dehumidification and cooling. However leakage between the polymer sheets is due to adhesive failure of joint between plastic sheet results in a decreasing of regenerator performance. The objectives of this project are to fabricate and simulate model of plate heat and mass exchanger and to study the adhesive strength used for heat and mass exchanger. The methodology for this project is started with the design of prototype plate heat and mass exchanger and material selection such as cyanoacrylate adhesive, silicon sealant and EVA Hot Melt Adhesive based on their properties and also polypropylene material as corrugated sheet and solid sheet material. Prior to adhesive test, heat treatment and surface roughening are prepared as surface preparation together with step to apply the adhesive to sample test. In order to test the maximum strength of the adhesive, the Single Lap Joint Shear Test is chosen for the adhesive test. After satisfying with the performance of adhesive, the fabrication of the heat and mass exchanger is started. Hydro testing of the model is conducted to test the leaking problem and also HMX working principle. 2D Design of Regenerator is designed to illustrate the model of plate heat and mass exchanger. Material selection for each component of regenerator is summarized by Bill of Material of Plate Heat and Mass Exchanger. From the single lap joint shear test, PP sample with treated surface bonded with cyanoacryalate adhesive achieved highest shear strength, 3.61MPa compared to untreated surface PP sample and other adhesive sample test. Besides, the result of hydro testing are also discussing about leaking problem of adhesive and also working principle of model. Most of leakage problem occurred due to improper fabrication technique and improper sealant used. Sealant of plastic joint is replaced from silicon sealant to EVA Hot Melt Adhesive. This adhesive able to fill the gap between the joint and resist the water from leaked. As a result, the leakage problem is minimized by using EVA Hot Melt Adhesive.

Item Type: Final Year Project
Subjects: T Technology > TJ Mechanical engineering and machinery
Departments / MOR / COE: Engineering > Mechanical
Depositing User: Users 5 not found.
Date Deposited: 21 May 2012 11:44
Last Modified: 25 Jan 2017 09:41
URI: http://utpedia.utp.edu.my/id/eprint/2403

Actions (login required)

View Item
View Item